Skip to content
newprotein.net Explore ingredients
Menu
Barley field ears at sunrise, a cutaway grain with protein layer near the husk, and fine barley protein powder

Plant proteins

Barley protein: extraction, functionality and uses

By the New Protein editorial team · Reviewed · 4 min read

Barley protein from malting and brewing streams: hordein and glutelin, alkaline and enzymatic extraction, solubility, foaming, colour, lysine, gluten.

Protein
60–83.2 %
Limiting amino acid
lysine
Strong at
Foaming
Diet
Vegan
Allergens
Gluten
Group
Plant proteins

What barley protein is and where it comes from

Barley protein is a family of proteins recovered from barley grain or, more often, from the solid residue of brewing. Whole barley carries between 8 and 30 percent protein, and malting varieties are bred towards the low end, with 10 to 12 percent as the usual target. That makes the grain a poor primary source.

Brewers’ spent grain is what remains after mashing. It holds about 19 to 30 percent protein on a total-grain basis, and one analysis listed 22.13 percent for spent grain against 9.65 percent for barley and 8.52 percent for malt. Roughly 30 percent of that protein consists of essential amino acids, which makes the residue nutritionally relevant.

The main storage proteins are hordeins, which are prolamins, and glutelin. Hordeins make up 30 to 50 percent of barley protein, mostly the B-type. Glutelin is the second most abundant group at 35 to 45 percent of storage protein. Albumins and globulins are minor. The page on brewers’ spent grain protein covers the supply stream in more detail.

Barley protein extraction routes

Barley protein extraction is difficult because the protein is bound to fibre and, after mashing, partly aggregated. During mashing, disulphide-linked hordein aggregates form the so-called hot trub. The aggregated protein coats the spent grain, so pre-treatment such as shearing or vigorous disruption can help before any solvent step, and shearing did raise yield in published work.

Alkaline extraction is the best-established route. A concentrate of 60 percent protein, dry basis, was obtained with 0.1 molar sodium hydroxide at 60 degrees Celsius for 60 minutes, followed by precipitation at pH 4.0. Another group found 110 millimolar alkali most efficient, and yield rose with temperature from 20 to 60 degrees.

Enzymatic routes use proteases instead. Alcalase solubilised up to 77 percent in one report, though other studies found 35 percent and 43 to 50 percent. Acid or alkaline pre-treatment can lift recovery to 90 or 95 percent but co-extracts lignin and carbohydrate. Ultrafiltration with 5 and 30 kilodalton membranes retained over 92 percent of protein.

Nutrition and amino acid profile

Cereal proteins are short in lysine, and barley follows the pattern. A commercial spent-grain isolate was compared with pea and soy isolates against the WHO amino acid requirement. It met or exceeded the requirement for every essential amino acid except lysine, which reached 81.1 percent. Pea reached 175.1 percent and soy 133.1 percent for lysine.

The picture reverses for sulphur amino acids. Methionine plus cysteine reached 151.3 percent of requirement in the barley isolate, against 33.9 percent for pea and 48.0 percent for soy. That complementarity makes blends logical, and the neighbouring pages on pea protein and rice protein show how legume and cereal proteins correct each other.

Raw material quality matters. Black spent grain, made from malt roasted above 200 degrees Celsius, had lower amino acid content than pale spent grain, probably through degradation or Maillard reactions. Protein content of the isolate itself was similar to its competitors at 83.22 grams per 100 grams dry matter, against 81.22 for pea and 89.22 for soy.

Barley protein functionality

Barley protein functionality depends heavily on how the protein was extracted. Raw spent grain showed negligible foaming and emulsifying, and hydrolysis improved both. With Alcalase or pepsin, these properties fell as the degree of hydrolysis rose, while Flavourzyme gave the opposite trend. Glutelin dissolves poorly and needed pH 11 to function in one account, which is impractical in food.

A commercial spent-grain isolate shows the extremes. Solubility measured 101.71 percent against 51.96 for soy and 22.27 for pea, which the authors attribute to extensive degradation into peptides. Foaming capacity reached 112.68 percent against 70.14 and 38.19, but foam stability at 60 minutes was only 45.57 percent against 74.31 and 80.12.

Emulsions and gels are the weak points. The isolate separated at 4.14 percent per minute against 0.99 for soy and 1.33 for pea, and it formed no gel at concentrations up to 22 percent, whereas soy gelled at 8 and pea at 14. A beverage built on it would likely need an added emulsifier.

Colour, flavour and processing issues

The isolate is much darker than its competitors. Lightness measured 57.42 against 84.69 for pea and 83.82 for soy, and the red value was 13.40 against 2.18 and 0.73. The authors link this to Maillard browning during malting and kilning, which means the colour is built in before any protein is extracted.

Flavour data are thin. In bread made with 10 percent spent grain, sweetness fell and acidulous flavour rose, although both breads were still acceptable. Lipid content can also drive off-flavours in storage, a general risk for any isolate with residual fat. Technologists planning light-coloured foods should therefore treat colour as the first screening criterion, not an afterthought.

Process design involves trade-offs. High alkali and temperature raise yield but darken the product and degrade protein. Mild enzymatic routes keep structure but add cost. Hydrolysis improves solubility at lower pH and foaming, yet it removes the gelation that bakery and meat analogues need. Each supplier lands at a different point on that curve.

Applications and regulatory status

Animal feed is the main current outlet. Spent grain can replace up to 50 percent of sow and weaner meal and 20 to 30 percent of fishmeal in trout and seabream feeds. For human food, extruded snacks with 10 to 30 percent spent grain gained protein, and at 10 percent nearly doubled fibre. Films with chitosan gained strength.

Barley is a cereal containing gluten, and Annex II of the EU food information regulation requires it to be declared and emphasised. That makes barley protein a poor fit for gluten-free positioning. It can suit foaming beverages, snacks or bakery where gluten is acceptable, and it competes there with oat protein and wheat gluten.

Buyers should ask suppliers which spent-grain stream is used, pale or dark, what extraction route and degree of hydrolysis apply, and what protein level, colour and microbiological limits are specified. Spent grain is perishable when wet, so drying speed and storage conditions affect quality. Sourcing follows brewery and malting locations, which concentrates supply near large breweries.

Frequently asked questions

What is barley protein?

A protein concentrate or isolate recovered from barley, most often from brewers' spent grain left after mashing. The grain contains about 19 to 30 percent protein, and extraction raises that to 60 percent or more.

Is barley protein gluten-free?

No. Barley is a cereal containing gluten and appears in Annex II of the EU food information regulation. Barley protein is therefore unsuitable for coeliac consumers and must be declared as a gluten-containing cereal.

What is the limiting amino acid in barley protein?

Lysine. A commercial spent-grain isolate met or exceeded the WHO requirement for every essential amino acid except lysine, at about 81 percent of requirement, while methionine plus cysteine reached about 151 percent.

How is barley protein extracted from spent grain?

Mostly with alkali. One method used 0.1 molar sodium hydroxide at 60 degrees Celsius for 60 minutes and precipitated at pH 4.0, giving a concentrate of 60 percent protein. Enzymes such as Alcalase are the main alternative.

Why is barley protein darker than pea protein?

Spent grain has been malted and kilned, so Maillard browning has already happened. A commercial isolate measured a lightness of 57 against 85 for a pea isolate, and a markedly higher red value.

Does barley protein form gels or emulsions?

Poorly. A spent-grain isolate formed no gel at concentrations up to 22 percent and separated quickly in emulsions, though it foamed strongly. Pea and soy isolates gelled at 14 and 8 percent.